topwater frog lure how to use

Well, prior to I got to recover on many of these casts a bass would blow up on the frog, and I talked to lots of bass that day. In each case the frog was just sitting stationary for at least one minute before I began the recover, and I captured bass only while it was sitting still.

So my pointer is, let the frog sit for a while prior to retrieving. You never understand what may surprise you! When fishing a frog with paddle feet, stitch the center point of the feet to the frog body with a piece of monofilament. Throughout a battle, this keeps the pair of legs from getting tugged out of one side of the frog body or the other, which will destroy the bait.

I have actually altered the length of it to look more like the frog is drifting with its legs outstretched. I have utilized this with excellent luck near weedbeds and my preferred method simply hopping it off the bank into the water throughout the summer. A number of us were on our way back home from a saltwater trip when we chose to make some casts into a little pond we had actually passed.

This unexpected whim of an adjustment kept the fish coming, and the natural feel of the bait seemed to keep them from tossing the frog. A strategy that I utilize when fishing a hollow-body frog typically a Bronzeye frog, however I am sure that it deals with others is what I call hopping.

The short jerks tend to make the frog plane up on the water, providing it a hopping movement similar to a live frog. Typically the strike will happen on the time out. You will need to experiment to see the length of time of a pause the fish want, and sometimes it is not required to stop briefly the lure at all.

To permit the frog to sit deeper in the water and cause more of a commotion when coming through weeds and the water, peel back the rubber frog body and make numerous wraps around the hook shank with a non-lead soldering wire. Develop different buoyancy characteristics by including or subtracting covers of the soldering wire.

This allows you to use an aroma that will slowly distribute into the water behind your bass-enticing frog! I also have included a jig rattle to the frog's hook shank to create much more commotion. I utilize the rubber jig type rattle holder. You can include either a single rattle or two rattles for even more sound.

Repeat a couple of times. This will bring in the attention of the bass, who at this moment is viewing from the cover. Now, cast your frog into the cover. Walk the frog in the cover and quickly enough the bass will assault. Hold your rod idea up high and count to 2.

I like tossing frogs and rats. To help zip them out there, I will push one or 2 small worm weights up into the hollow body. They assist pitch the lure out there further, and they act as a rattle as I chug it back to the boat. Cast the frog onto the bank and pull it into the water about 6 inches off the bank.

Sometimes a still bait is a simple meal for a bass. Have you ever seen a frog chased off the bank by a snake? The frog will strike the water and swim in 2 or three frantic spurts, practically clearing the water. If your regular technique of fishing your frog appears to not be drawing interest, attempt casting to the waterline and reeling your frog in two or three quick spurts with a quick time out in between each.

A bass will blast the frog as if to disable it and will strike a second time if you do not reel it away. Often this frenzied frog presentation will draw strikes when others will not. Lots of times I'll get more bites by simply casting the frog onto the shore if the shoreline is open enough.

By dragging the frog in from dry land, this produces a more natural entry into the water. A pointer for fishing plastic frogs utilizing braided line: If you use a silicone dry fly spray or paste to the first 5 feet of the line, it will keep the line floating on the surface area, ensuring much better hook sets and frog efficiency.

After the cast, provide the frog a medium powered jerk and the frog will hop out of the water. Fly tiers have actually utilized this technique on their poppers for ages, yet you never ever hear or see anything about it. Functions like a charm, whenever. Use 3/16-inch orthodontics elastics one-third of the method up each leg skirt, doubling the flexible to hold the skirt product tightly together, like a collar on a spinnerbait or jig skirt.

This is more efficient in open water fishing because the leg skirts are united, making for a less weedless discussion. The advantage of this modification is that it makes the frog walk more efficiently and look more realistic! When you're fishing a frog or any topwater lure, you need to be incredibly patient not just prior to a strike but after, too.

I can't count the number of times excitement took over when a big bass exploded on my frog, and I jerked it far from the bass before he could actually take it. Here are a couple of suggestions I have actually discovered for many years to increase your variety of strikes and hookups with a frog.

There are 2 ways to do this. One method is to pull the skirt material out of the rear of the frog. Place 8 brass rattles made for tube baits into the holes where you pulled the skirt out. Utilizing a piece of 25-pound mono, Super Glue the line to the center of the skirt.

Pull the line and skirt out to length and cut the line. The next way is the easiest. Cut a small hole in the top rear of the frog. Place rattles through the cut hole and usage silicone to plug the hole. Cut the skirt off 1 inch long on each side.

I utilize a heat weapon or blow clothes dryer to make the bait concave on top, even though the bait is hollow. Start 1/4-inch in front of the hook point and go 1 inch forward. Just concave about 1/4-inch deep. The bait will be simply as weedless, and your connection ratio will increase.

They include weight to make the bait sit lower in the mat and likewise sound to bring in fish. Toss your frog into the mat, move it a couple of inches and shake it in one place. Then move it a few inches and repeat. You need to offer the fish time to find the bait in thick mats.

Try to cast it in near to hang over completion of a tree branch. Reel it in till it's hanging vertically off the branch. (In some cases it gets knocked early.) Just bob it up and down with the legs dangling in the water. When the bass grabs it and the line snaps off completion of the branch, there is sufficient slack so you won't set the hook too early.

On some frogs, the skirt that comprises the legs runs in one side of the frog and out the other. If you pull on one leg and make it a bit longer than the other, the bait will have some walk-the-dog action on its own. The most apparent suggestion is my favorite: Match the hatch.

We use the smallest frog we can locate, toss it up on the bank or coastline, and "pop" it into the water. Let it sit for no more than two seconds, and pop it away from the dirt. This remains in open water and right up against standing tules, sunken brush and fallen trees.

Sometimes, I could not count the variety of big bass that I captured out of these little locations. As I walked the bank, I was always scaring up frogs, usually leopard frogs. Today, there are many types and producers of frogs, however back in the day, there were very couple of.

Those little children were good right out of the box, however required more action for the angler to not need to put forth the effort. While taking a break one evening, I was taking a look at my frog and wondering what might be done. I started to take apart the frog and I observed the skirt simply slipped over the hook.

When I put the skirt back on, I recognized that I had actually put it on in reverse. When the rod was jerked to make the frog move, the skirt would correct, similar to the legs of a live frog, and when the frog was resting, the skirt flared out much like a frog does when it is resting on the water.

Attempt this little technique for affordable baits to get more action out of them. The technique can be used on rats in addition to spinnerbaits that have a "one-way skirt," like the H&H Spinner. This little tip will certainly help you put more bass in the boat. Casting the frog straight onto the bank (on dry ground) is an excellent way to get bass to bite.

Cast the frog high and let it hit the moss with a loud plop. Simply let it sit there. With the rod suggestion held high, don't move the frog however simply plop it numerous times, moving the moss. Hop it once and hang on. I've been fishing on Lake Texoma for rather some time and my mother of all people acquired some weedless frogs out of an Outdoor Life publication that at the time were the huge buzz for catching bass.

When we began casting we expected to catch fish near the shoreline, but as we gradually retrieved and stopped briefly the frog we did not get any hits till the lure was relatively near to the boat. I was still an amateur it took me a number of missed out on fish before I remembered fishing on a pond in Rhode Island where my dad informed me to count to 10 before setting the hook.

For a totally quiet but lethal lure presentation, cast your frog onto the coast and pull it into the water. I find this to work more times than not. It doesn't matter if there is cover or simply open water if you discover a spot that is regularly under shade, causing the water temperatures to stay a little lower than the remainder of the pond/lake.

We would cast our frogs out over the moss that extended out over the edge of the pond roughly 20 approximately feet. We would erupt as far as we could, then stroll the frog in to the edge of the moss. If we didn't get a bite en route in, we would let the frog sit at the external edge of the moss and after that wiggle the tip of our poles to make the frog shake.

Speak about thrilling! While fishing one day I saw a huge bass come out from under a log at the edge of some lily pads to look at the buzzbait I was pitching at the time. Over the next numerous days, I boiled down and fished that spot a minimum of when a day with different lures and techniques to try to bring this bass to strike.

topwater frog lure how to use

when to throw topwater frog