how to make a topwater frog

Well, prior to I got to retrieve on the majority of these casts a bass would blow up on the frog, and I hooked up with numerous bass that day. In each case the frog was simply sitting stationary for at least one minute before I started the obtain, and I caught bass just while it was sitting still.

So my suggestion is, let the frog sit for a while before retrieving. You never know what may shock you! When fishing a frog with paddle feet, stitch the center point of the feet to the frog body with a piece of monofilament. During a fight, this keeps the pair of legs from getting yanked out of one side of the frog body or the other, which will destroy the bait.

I have actually changed the length of it to look more like the frog is floating with its legs outstretched. I have used this with best of luck near weedbeds and my favorite method simply hopping it off the bank into the water during the summer season. A number of us were on our way back home from a saltwater journey when we chose to make some casts into a small pond we had actually passed.

This sudden whim of an adjustment kept the fish coming, and the natural feel of the bait appeared to keep them from throwing the frog. A technique that I use when fishing a hollow-body frog typically a Bronzeye frog, however I make certain that it deals with others is what I call hopping.

The brief jerks tend to make the frog aircraft up on the water, offering it a hopping motion similar to a live frog. Typically the strike will happen on the time out. You will need to experiment to see the length of time of a pause the fish desire, and in some cases it is not essential to pause the lure at all.

To permit the frog to sit deeper in the water and cause more of a commotion when coming through weeds and the water, peel back the rubber frog body and make a number of wraps around the hook shank with a non-lead soldering wire. Develop various buoyancy qualities by including or subtracting wraps of the soldering wire.

This permits you to use a scent that will slowly disperse into the water behind your bass-enticing frog! I likewise have actually included a jig rattle to the frog's hook shank to develop much more commotion. I use the rubber jig type rattle holder. You can add either a single rattle or more rattles for a lot more sound.

Repeat a couple of times. This will bring in the attention of the bass, who at this point is viewing from the cover. Now, cast your frog into the cover. Walk the frog in the cover and quickly enough the bass will assault. Hold your rod suggestion up high and count to 2.

I like tossing frogs and rats. To assist zip them out there, I will shove a couple of small worm weights up into the hollow body. They help pitch the lure out there farther, and they act as a rattle as I chug it back to the boat. Cast the frog onto the bank and pull it into the water about 6 inches off the bank.

In some cases a still bait is a simple meal for a bass. Have you ever seen a frog chased after off the bank by a snake? The frog will hit the water and swim in two or three frantic spurts, almost clearing the water. If your regular approach of fishing your frog appears to not be drawing interest, try casting to the waterline and reeling your frog in 2 or three fast spurts with a fast time out between each.

A bass will blast the frog as if to disable it and will strike a second time if you don't reel it away. Sometimes this frenzied frog presentation will draw strikes when others will not. Sometimes I'll get more bites by simply casting the frog onto the coast if the coastline is open enough.

By dragging the frog in from dry land, this develops a more natural entry into the water. A tip for fishing plastic frogs utilizing braided line: If you use a silicone dry fly spray or paste to the very first 5 feet of the line, it will keep the line drifting on the surface area, guaranteeing better hook sets and frog efficiency.

After the cast, provide the frog a medium powered jerk and the frog will hop out of the water. Fly tiers have utilized this trick on their poppers for ages, yet you never ever hear or see anything about it. Functions like a beauty, whenever. Usage 3/16-inch orthodontics elastics one-third of the method up each leg skirt, doubling the elastic to hold the skirt material tightly together, like a collar on a spinnerbait or jig skirt.

This is more effective in open water fishing due to the fact that the leg skirts are united, making for a less weedless presentation. The advantage of this change is that it makes the frog walk better and look more lifelike! When you're fishing a frog or any topwater lure, you have to be incredibly patient not only before a strike however after, too.

I can't count the number of times excitement took over when a big bass took off on my frog, and I jerked it far from the bass before he could actually take it. Here are a couple of suggestions I have actually discovered over the years to increase your number of strikes and hookups with a frog.

There are 2 methods to do this. One method is to pull the skirt material out of the rear of the frog. Insert eight brass rattles produced tube baits into the holes where you pulled the skirt out. Using a piece of 25-pound mono, Super Glue the line to the center of the skirt.

Pull the line and skirt out to length and cut the line. The next way is the easiest. Cut a small hole in the top rear of the frog. Insert rattles through the cut hole and use silicone to plug the hole. Cut the skirt off 1 inch long on each side.

I utilize a heat gun or blow dryer to make the bait concave on top, even though the bait is hollow. Start 1/4-inch in front of the hook point and go 1 inch forward. Just concave about 1/4-inch deep. The bait will be just as weedless, and your hookup ratio will increase.

They add weight to make the bait sit lower in the mat and also sound to draw in fish. Throw your frog into the mat, move it a couple of inches and shake it in one location. Then move it a few inches and repeat. You have to offer the fish time to discover the bait in thick mats.

Attempt to cast it in near to hang over completion of a tree branch. Reel it in till it's hanging vertically off the branch. (Sometimes it gets slammed early.) Simply bob it up and down with the legs hanging in the water. When the bass gets it and the line snaps off the end of the branch, there suffices slack so you won't set the hook too early.

On some frogs, the skirt that makes up the legs runs in one side of the frog and out the other. If you pull on one leg and make it a little bit longer than the other, the bait will have some walk-the-dog action on its own. The most obvious idea is my favorite: Match the hatch.

We use the tiniest frog we can locate, toss it up on the bank or coastline, and "pop" it into the water. Let it sit for no greater than 2 seconds, and pop it far from the dirt. This is in open water and right up versus standing tules, sunken brush and fallen trees.

At times, I couldn't count the number of large bass that I caught out of these little locations. As I walked the bank, I was always scaring up frogs, typically leopard frogs. Today, there are lots of types and manufacturers of frogs, however in the past, there were very couple of.

Those little babies were excellent right out of package, however required more action for the angler to not need to present the effort. While taking a break one evening, I was looking at my frog and questioning what could be done. I began to take apart the frog and I noticed the skirt simply slipped over the hook.

When I put the skirt back on, I understood that I had actually put it on backwards. When the rod was jerked to make the frog relocation, the skirt would straighten out, much like the legs of a live frog, and when the frog was resting, the skirt flared out similar to a frog does when it is resting on the water.

Attempt this little technique for low-cost baits to get more action out of them. The technique can be utilized on rats as wells as spinnerbaits that have a "one-way skirt," like the H&H Spinner. This little tip will definitely assist you put more bass in the boat. Casting the frog directly onto the bank (on dry ground) is a fantastic way to get bass to bite.

Cast the frog high and let it strike the moss with a loud plop. Simply let it sit there. With the rod pointer held high, don't move the frog however just plop it numerous times, moving the moss. Hop it once and hang on. I've been fishing on Lake Texoma for quite a long time and my mom of all people acquired some weedless frogs out of an Outdoor Life magazine that at the time were the huge buzz for catching bass.

When we began casting we anticipated to catch fish near to the shoreline, but as we gradually obtained and stopped briefly the frog we did not get any hits till the lure was relatively near to the boat. I was still a novice it took me a number of missed out on fish before I kept in mind fishing on a pond in Rhode Island where my dad informed me to count to 10 before setting the hook.

For a completely quiet however deadly lure discussion, cast your frog onto the shore and pull it into the water. I find this to work more times than not. It does not matter if there is cover or simply open water if you find an area that is consistently under shade, triggering the water temps to stay a little lower than the remainder of the pond/lake.

We would cast our frogs out over the moss that extended over the edge of the pond roughly 20 or two feet. We would erupt as far as we could, then stroll the frog in to the edge of the moss. If we didn't get a bite en route in, we would let the frog sit at the outer edge of the moss and after that wiggle the pointer of our poles to make the frog shake.

Talk about thrilling! While fishing one day I saw a substantial bass come out from under a log at the edge of some lily pads to take a look at the buzzbait I was pitching at the time. Over the next numerous days, I came down and fished that area at least when a day with various lures and techniques to try to bring this bass to strike.

how to make a topwater frog

how to fish frogs on topwater