how to use topwater frog lure

Well, prior to I got to retrieve on many of these casts a bass would blow up on the frog, and I talked to numerous bass that day. In each case the frog was just sitting stationary for a minimum of one minute prior to I started the recover, and I caught bass just while it was sitting still.

My suggestion is, let the frog sit for a while before recovering. You never ever know what may shock you! When fishing a frog with paddle feet, stitch the center point of the feet to the frog body with a piece of monofilament. During a fight, this keeps the set of legs from getting yanked out of one side of the frog body or the other, which will destroy the bait.

I have altered the length of it to look more like the frog is floating with its legs outstretched. I have utilized this with best of luck near weedbeds and my preferred way simply hopping it off the bank into the water during the summer. A couple of us were on our way back home from a saltwater trip when we decided to make some casts into a little pond we had actually passed.

This sudden whim of an adjustment kept the fish coming, and the natural feel of the bait appeared to keep them from tossing the frog. A technique that I utilize when fishing a hollow-body frog normally a Bronzeye frog, however I am sure that it deals with others is what I call hopping.

The short jerks tend to make the frog plane up on the water, offering it a hopping motion similar to a live frog. Normally the strike will take place on the pause. You will need to experiment to see how long of a time out the fish want, and sometimes it is not needed to pause the lure at all.

To permit the frog to sit much deeper in the water and cause more of a commotion when coming through weeds and the water, peel back the rubber frog body and make a number of twists around the hook shank with a non-lead soldering wire. Develop various buoyancy characteristics by including or subtracting wraps of the soldering wire.

This allows you to apply a scent that will gradually disperse into the water behind your bass-enticing frog! I likewise have added a jig rattle to the frog's hook shank to produce even more commotion. I use the rubber jig type rattle holder. You can add either a single rattle or 2 rattles for a lot more noise.

Repeat a few times. This will draw in the attention of the bass, who at this moment is watching from the cover. Now, cast your frog into the cover. Walk the frog in the cover and quickly enough the bass will attack. Hold your rod pointer up high and count to two.

I like tossing frogs and rats. To help zip them out there, I will push a couple of small worm weights up into the hollow body. They help pitch the lure out there further, and they act as a rattle as I down it back to the boat. Cast the frog onto the bank and pull it into the water about 6 inches off the bank.

Sometimes a still bait is a simple meal for a bass. Have you ever seen a frog went after off the bank by a snake? The frog will hit the water and swim in 2 or three frenzied spurts, almost clearing the water. If your routine technique of fishing your frog seems to not be drawing interest, attempt casting to the waterline and reeling your frog in two or three fast spurts with a fast pause in between each.

A bass will blast the frog as if to disable it and will strike a 2nd time if you do not reel it away. Sometimes this frantic frog discussion will draw strikes when others won't. Sometimes I'll get more bites by just casting the frog onto the shore if the shoreline is open enough.

By dragging the frog in from dry land, this creates a more natural entry into the water. A tip for fishing plastic frogs utilizing braided line: If you use a silicone dry fly spray or paste to the first 5 feet of the line, it will keep the line drifting on the surface area, guaranteeing better hook sets and frog performance.

After the cast, provide the frog a medium powered jerk and the frog will hop out of the water. Fly tiers have actually used this technique on their poppers for ages, yet you never ever hear or see anything about it. Works like a charm, each time. Usage 3/16-inch orthodontics elastics one-third of the method up each leg skirt, doubling the flexible to hold the skirt material firmly together, like a collar on a spinnerbait or jig skirt.

This is more reliable in open water fishing because the leg skirts are banded together, producing a less weedless discussion. The benefit of this alteration is that it makes the frog walk better and look more realistic! When you're fishing a frog or any topwater lure, you need to be incredibly patient not just before a strike but after, too.

I can't count how numerous times enjoyment took over when a huge bass took off on my frog, and I jerked it away from the bass prior to he might truly take it. Here are a few suggestions I have actually found out over the years to increase your number of strikes and connections with a frog.

There are two ways to do this. One method is to pull the skirt product out of the rear of the frog. Insert 8 brass rattles produced tube baits into the holes where you pulled the skirt out. Utilizing a piece of 25-pound mono, Super Glue the line to the center of the skirt.

Pull the line and skirt out to length and cut the line. The next way is the simplest. Cut a small hole in the top back of the frog. Insert rattles through the cut hole and usage silicone to plug the hole. Cut the skirt off 1 inch long on each side.

I utilize a heat gun or blow clothes dryer to make the bait concave on top, even though the bait is hollow. Start 1/4-inch in front of the hook point and go 1 inch forward. Just concave about 1/4-inch deep. The bait will be just as weedless, and your connection ratio will increase.

They add weight to make the bait sit lower in the mat and also sound to bring in fish. Throw your frog into the mat, move it a few inches and shake it in one location. Then move it a few inches and repeat. You need to offer the fish time to find the bait in thick mats.

Try to cast it in close to hang over completion of a tree branch. Reel it in till it's hanging vertically off the branch. (In some cases it gets knocked early.) Simply bob it up and down with the legs dangling in the water. When the bass gets it and the line snaps off the end of the branch, there is sufficient slack so you will not set the hook too early.

On some frogs, the skirt that makes up the legs runs in one side of the frog and out the other. If you pull on one leg and make it a little longer than the other, the bait will have some walk-the-dog action by itself. The most apparent tip is my favorite: Match the hatch.

We use the tiniest frog we can find, toss it up on the bank or coastline, and "pop" it into the water. Let it sit for no more than two seconds, and pop it far from the dirt. This is in open water and right up versus standing tules, sunken brush and fallen trees.

Sometimes, I could not count the number of big bass that I caught out of these little locations. As I strolled the bank, I was constantly terrifying up frogs, normally leopard frogs. Today, there are many types and makers of frogs, however in the past, there were really couple of.

Those little children were good right out of the box, however required more action for the angler to not need to put forth the effort. While taking a break one night, I was looking at my frog and wondering what might be done. I started to take apart the frog and I saw the skirt simply slipped over the hook.

When I put the skirt back on, I recognized that I had put it on in reverse. When the rod was jerked to make the frog relocation, the skirt would straighten, similar to the legs of a live frog, and when the frog was resting, the skirt flared out similar to a frog does when it is resting on the water.

Attempt this little trick for low-cost baits to get more action out of them. The method can be utilized on rats in addition to spinnerbaits that have a "one-way skirt," like the H&H Spinner. This little suggestion will definitely help you put more bass in the boat. Casting the frog straight onto the bank (on dry ground) is a terrific method to get bass to bite.

Cast the frog high and let it strike the moss with a loud plop. Just let it sit there. With the rod pointer held high, do not move the frog however simply plop it several times, moving the moss. Then hop it once and hold on. I've been fishing on Lake Texoma for quite some time and my mom of all individuals bought some weedless frogs out of an Outdoor Life publication that at the time were the huge buzz for catching bass.

When we started casting we anticipated to capture fish near to the shoreline, but as we gradually recovered and paused the frog we did not get any hits till the lure was fairly close to the boat. I was still a newbie it took me several missed out on fish before I remembered fishing on a pond in Rhode Island where my daddy informed me to count to 10 prior to setting the hook.

For a totally quiet but deadly lure discussion, cast your frog onto the shore and pull it into the water. I discover this to work more times than not. It doesn't matter if there is cover or just open water if you discover a spot that is consistently under shade, triggering the water temps to remain a little lower than the remainder of the pond/lake.

We would cast our frogs out over the moss that extended over the edge of the pond around 20 approximately feet. We would erupt as far as we could, then stroll the frog in to the edge of the moss. If we didn't get a bite on the method in, we would let the frog sit at the outer edge of the moss and then wiggle the pointer of our poles to make the frog shake.

Speak about thrilling! While fishing one day I saw a big bass come out from under a log at the edge of some lily pads to look at the buzzbait I was pitching at the time. Over the next several days, I came down and fished that area at least when a day with different lures and tactics to attempt to bring this bass to strike.

how to use topwater frog lure

how to use topwater frog for bass