how to fish with topwater frog

Well, prior to I got to retrieve on the majority of these casts a bass would take off on the frog, and I hooked up with lots of bass that day. In each case the frog was simply sitting stationary for at least one minute prior to I started the obtain, and I captured bass only while it was sitting still.

So my pointer is, let the frog sit for a while prior to obtaining. You never ever know what might shock you! When fishing a frog with paddle feet, sew the center point of the feet to the frog body with a piece of monofilament. During a fight, this keeps the set of legs from getting pulled out of one side of the frog body or the other, which will destroy the bait.

I have actually altered the length of it to look more like the frog is drifting with its legs outstretched. I have used this with best of luck near weedbeds and my preferred way just hopping it off the bank into the water during the summer season. A couple of us were on our method back home from a saltwater journey when we chose to make some casts into a little pond we had passed.

This abrupt impulse of a modification kept the fish coming, and the natural feel of the bait seemed to keep them from tossing the frog. A method that I use when fishing a hollow-body frog normally a Bronzeye frog, but I am sure that it deals with others is what I call hopping.

The short jerks tend to make the frog airplane up on the water, giving it a hopping motion similar to a live frog. Generally the strike will occur on the time out. You will need to experiment to see the length of time of a pause the fish want, and often it is not necessary to pause the lure at all.

To permit the frog to sit deeper in the water and trigger more of a commotion when coming through weeds and the water, peel back the rubber frog body and make several wraps around the hook shank with a non-lead soldering wire. Create different buoyancy qualities by including or subtracting wraps of the soldering wire.

This allows you to use an aroma that will slowly disperse into the water behind your bass-enticing frog! I also have added a jig rattle to the frog's hook shank to create much more turmoil. I utilize the rubber jig type rattle holder. You can include either a single rattle or two rattles for much more noise.

Repeat a few times. This will bring in the attention of the bass, who at this moment is watching from the cover. Now, cast your frog into the cover. Walk the frog in the cover and quickly enough the bass will assault. Hold your rod pointer up high and count to two.

I like tossing frogs and rats. To assist zip them out there, I will shove a couple of little worm weights up into the hollow body. They help pitch the lure out there farther, and they function as a rattle as I chug it back to the boat. Cast the frog onto the bank and pull it into the water about 6 inches off the bank.

Often a still bait is a simple meal for a bass. Have you ever seen a frog chased off the bank by a snake? The frog will hit the water and swim in 2 or three frantic spurts, nearly clearing the water. If your routine method of fishing your frog seems to not be drawing interest, attempt casting to the waterline and reeling your frog in two or 3 quick spurts with a fast time out in between each.

A bass will blast the frog as if to disable it and will strike a 2nd time if you do not reel it away. Sometimes this frenzied frog discussion will draw strikes when others won't. Lot of times I'll get more bites by simply casting the frog onto the shore if the shoreline is open enough.

By dragging the frog in from dry land, this develops a more natural entry into the water. An idea for fishing plastic frogs utilizing braided line: If you use a silicone dry fly spray or paste to the first 5 feet of the line, it will keep the line floating on the surface, making sure better hook sets and frog efficiency.

After the cast, provide the frog a medium powered jerk and the frog will hop out of the water. Fly tiers have utilized this trick on their poppers for ages, yet you never ever hear or see anything about it. Works like a beauty, every time. Usage 3/16-inch orthodontics elastics one-third of the way up each leg skirt, doubling the elastic to hold the skirt product tightly together, like a collar on a spinnerbait or jig skirt.

This is more reliable in open water fishing since the leg skirts are banded together, making for a less weedless discussion. The advantage of this alteration is that it makes the frog walk more efficiently and look more natural! When you're fishing a frog or any topwater lure, you need to be incredibly patient not just prior to a strike however after, too.

I can't count how many times enjoyment took control of when a big bass took off on my frog, and I jerked it far from the bass prior to he could really take it. Here are a few ideas I have actually learned for many years to increase your number of strikes and hookups with a frog.

There are two ways to do this. One way is to pull the skirt material out of the rear of the frog. Insert eight brass rattles produced tube baits into the holes where you pulled the skirt out. Utilizing a piece of 25-pound mono, Super Glue the line to the center of the skirt.

Pull the line and skirt out to length and cut the line. The next method is the most basic. Cut a little hole in the leading back of the frog. Place rattles through the cut hole and use silicone to plug the hole. Cut the skirt off 1 inch long on each side.

I utilize a heat gun or blow dryer to make the bait concave on top, although the bait is hollow. Start 1/4-inch in front of the hook point and go 1 inch forward. Just concave about 1/4-inch deep. The bait will be just as weedless, and your hookup ratio will increase.

They include weight to make the bait sit lower in the mat and likewise noise to attract fish. Toss your frog into the mat, move it a couple of inches and shake it in one place. Move it a couple of inches and repeat. You have to offer the fish time to discover the bait in thick mats.

Try to cast it in near hang over completion of a tree branch. Reel it in till it's hanging vertically off the branch. (Sometimes it gets slammed early.) Just bob it up and down with the legs dangling in the water. When the bass gets it and the line snaps off the end of the branch, there suffices slack so you will not set the hook too early.

On some frogs, the skirt that makes up the legs runs in one side of the frog and out the other. If you pull on one leg and make it a little bit longer than the other, the bait will have some walk-the-dog action by itself. The most apparent tip is my favorite: Match the hatch.

We utilize the smallest frog we can find, toss it up on the bank or shoreline, and "pop" it into the water. Let it sit for no more than 2 seconds, and pop it away from the dirt. This is in open water and right up against standing tules, sunken brush and fallen trees.

At times, I couldn't count the number of large bass that I caught out of these little places. As I strolled the bank, I was constantly frightening up frogs, usually leopard frogs. Today, there are numerous types and manufacturers of frogs, however in the past, there were really few.

Those little children were great right out of package, but required more action for the angler to not need to present the effort. While taking a break one night, I was looking at my frog and wondering what could be done. I began to take apart the frog and I saw the skirt just slipped over the hook.

When I put the skirt back on, I understood that I had actually put it on backwards. When the rod was jerked to make the frog move, the skirt would straighten, similar to the legs of a live frog, and when the frog was resting, the skirt flared out similar to a frog does when it is resting on the water.

Try this little technique for economical baits to get more action out of them. The method can be utilized on rats in addition to spinnerbaits that have a "one-way skirt," like the H&H Spinner. This little suggestion will definitely help you put more bass in the boat. Casting the frog directly onto the bank (on dry ground) is a great way to get bass to bite.

Cast the frog high and let it hit the moss with a loud plop. Simply let it sit there. With the rod suggestion held high, do not move the frog however just plop it numerous times, moving the moss. Hop it when and hang on. I have actually been fishing on Lake Texoma for quite a long time and my mother of all individuals acquired some weedless frogs out of an Outdoor Life magazine that at the time were the huge buzz for catching bass.

When we started casting we expected to capture fish close to the shoreline, but as we slowly recovered and stopped briefly the frog we did not get any hits up until the lure was reasonably near to the boat. I was still an amateur it took me numerous missed fish before I kept in mind fishing on a pond in Rhode Island where my father informed me to count to 10 before setting the hook.

For a completely silent but deadly lure discussion, cast your frog onto the coast and pull it into the water. I find this to work more times than not. It doesn't matter if there is cover or just open water if you discover an area that is consistently under shade, causing the water temps to stay a little lower than the rest of the pond/lake.

We would cast our frogs out over the moss that stretched out over the edge of the pond approximately 20 or so feet. We would erupt as far as we could, then stroll the frog in to the edge of the moss. If we didn't get a bite en route in, we would let the frog sit at the outer edge of the moss and then wiggle the idea of our poles to make the frog shake.

Speak about thrilling! While fishing one day I saw a substantial bass come out from under a log at the edge of some lily pads to look at the buzzbait I was pitching at the time. Over the next several days, I boiled down and fished that spot a minimum of when a day with different lures and tactics to attempt to bring this bass to strike.

how to fish with topwater frog

how to use top water frog